Kinetic Technologies provides power management LED lighting control, an Ethernet port, plus EMI/ESD and surge protection solutions for Networking switching equipment.


Buck and Boost Converter

Part Number Description
KTB8330 3A, 2.4MHz, Low-Voltage, I2C Programmable Buck Regulator
KTB8371 4.7V to 17V Input, 5A Synchronous Buck Regulator with I2C Interface
KTB8372 4.7V to 18V Input, 5A Synchronous Buck Regulators with AOT Control

EMI/ESD Suppression

Kinetic Technologies’ EMI/ESD Suppression solution is the industry’s first of a kind, integrating ESD and Common Mode EMI suppression IC to improve EMC performance in Ethernet applications. It is built around Kinetic Technologies’ patented and proprietary Active EMC suppression technology to enable a “Design for Compliance” approach to system design right from the start. This product helps eliminate EMC compliance challenges by providing consistent EMC performance and improvements utilizing silicon-based technology as opposed to passive technologies. EMI/ESD suppression by Kinetic Technologies enables system designers to comply with:

  • CISPR22 and FCC Part 15, Class B requirements for Radiated and Conducted Emissions.
  • IEC 61000-4-3/6 requirements for Radiated and Conducted Immunity, Level 3 or higher.
  • IEC 61000-4-2 ESD (Air Discharge) of ±25kV.
  • IEC 61000-4-2 ESD (Contact Discharge) of ±12kV.
  • Cable Discharge Event (CDE) of ±12kV.
Part Number Description
KTA1550 Dual-channel Active choke for EMI suppression w/ Integrated ESD Protection
KTA1552 Quad Channel Active EMI & ESD Suppressor for Ethernet Applications

Overvoltage and Surge Protection ICs

Part Number Description
KTS1640 Load Switch with OVP and Reverse Polarity Protection
KTS1641 Load Switch with OVP and Reverse Polarity Protection

PoE PD Controllers

Part Number Description
KTB1095 Isolated Synchronous Flyback Controller with Integrated Feedback and Digital Isolator

RGB LED Drivers

Telecom and network switching equipment often use LED indicator lamps. Indicator lamps show power on/off or function status. Implementing indicator lamp LED control circuits to interface LED control switching to microcontroller logic is a tedious design process and requires multiple discrete components.

  • RGB LED drivers allow simplified programmable control of LED color and brightness

Product Highlights:

  • 3-channel RGB LED drivers permit custom color control
  • 4-channel RGBW devices allow for driving a white LED in addition to the RGB LED
  • I2C to ease integration with a wide variety of processors and operating systems
  • Wide range of ramp up/down timing for slow fade in/out effects and complex repeating patterns
  • Ultra-small package footprint
Part Number Description
KTD2026 3-Channel RGB LED Driver with I2C Control
KTD2027 4-Channel RGBW LED Driver with I2C Control

USB Data Line Protection ICs

Part Number Description
KTU1120 USB Type-C Port Protector for CC and SBU Pins
KTU1121 USB Type-C Port Protector for CC and SBU Pins
KTU1121A USB Type-C Port Protector for CC and SBU Pins
KTU1128 USB Type-C 28V EPR Port Protector for CC and SBU Pins
KTU1131 USB Type-C Port Protector for CC, SBU and D+/- Pins